Skip to content
Safety

Water Heater Earthquake Straps: California Requirements

In an earthquake, an unstrapped water heater can tip over, break the gas line and flood the house. Straps are simple, cheap and required by law.

By Covina Water Heater Pros · · 2 min read

Water Heater Earthquake Straps: California Requirements

Quick answer

California requires tank water heaters to be braced with two seismic straps: one in the upper third of the tank and one in the lower third, with the lower strap at least 4 inches above the controls. Straps must be anchored into wall studs or masonry. Strapping is also required when a home is sold.

Need it fixed today? Call (626) ***-****

Why Straps Matter in Covina

Covina sits in one of the most seismically active regions in the country. A 50-gallon tank full of water weighs over 400 pounds. In a strong quake, an unstrapped heater can walk, tip and snap its gas and water lines, causing fires, gas leaks and flooding. Straps keep it in place.

The Placement Rules

  • Two straps for typical residential tanks (larger tanks may need more).
  • Upper strap in the top third of the tank.
  • Lower strap in the bottom third, at least 4 inches above the gas controls.
  • Anchored into studs or masonry with lag screws, not just drywall.
  • Tight to the tank with minimal gap between tank and wall; a spacer block may be needed.
  • Flexible connectors for gas and water lines so they can move without breaking.

Pro tip: Look for straps that are listed and labeled for seismic use. Plumber's tape alone is generally not acceptable.

Not sure what's wrong with your water heater?

Talk to a local Covina technician now. Honest advice, upfront pricing.

(626) ***-****

How to Check Your Straps

  1. Count the straps and check their height on the tank.
  2. Push on the tank. It shouldn't move more than slightly.
  3. Look at the wall anchors. Are they in studs?
  4. Check that gas and water lines are flexible, not rigid pipe.
  5. Make sure nothing heavy is stored where it could fall on the heater.

Strapping and Home Sales

California law requires sellers to certify that water heaters are properly braced. Home inspectors routinely flag missing or loose straps. If you're buying or selling, see our home inspection guide.

Every water heater we install includes code-compliant seismic strapping. We also add or correct straps on existing heaters. See our installation service.

This article is general information for Covina-area homeowners. Gas, venting and electrical work should be done by a licensed professional. For help with your specific water heater, call (626) ***-****.

Frequently Asked Questions

Tankless units are wall-mounted with brackets, so they don't need tank straps. They still need secure mounting and flexible connections.
Many homeowners do, using a listed strap kit and lag screws into studs. If you're unsure about placement or anchoring, have a plumber check it.
Yes. Seismic strapping is checked during the permit inspection for any new or replacement tank water heater.

Are Your Straps Up to Code?

We install and correct seismic strapping across Covina.

Call (626) ***-****
Call Now Free Quote